;-----------------------------------------------------------------------------\
; 
;  Changed for use with Tim Duda's 300KHZ unit on EN425
;
;
;ADCP Command File for use with VmDas software.
; 
; ADCP type:     75 Khz Ocean Surveyor
; Setup name:    default
; Setup type:    High resolution, short range profile(broadband)
; 
; NOTE:  Any line beginning with a semicolon in the first 
;        column is treated as a comment and is ignored by 
;        the VmDas software.
;
; NOTE:  This file is best viewed with a fixed-point font (eg. courier).
;----------------------------------------------------------------------------/

; Restore factory default settings in the ADCP
cr1

; set the data collection baud rate to 115200 bps, 
; no parity, one stop bit, 8 data bits
; NOTE:  VmDas sends baud rate change command after all other commands in 
; this file, so that it is not made permanent by a CK command.
cb811

; Set for broadband profile mode, single-ping ensembles, 
; 128 - 4 meter bins, 4 meter blanking distance, 390 mm/s ambiguity vel
; NP0  Was an OS75 command, not used for BB 300khz, we think...
WP00001
WS0400
WF0400
WN064
WV390

; Enable single-ping bottom track, 
; Set maximum bottom search depth to 500 meters
BP001
BX5000

; output velocity, correlation, echo intensity, percent good
WD111100000

; one seconds between bottom and water pings
TP000100

; Four seconds between ensembles
; Since VmDas uses manual pinging, TE is ignored by the ADCP.
; You must set the time between ensemble in the VmDas Communication options
TE00000400

; Set to calculate speed-of-sound, no depth sensor, 
; external synchro heading sensor, use internal 
; transducer temperature sensor
EZ1020001

; Output beam data (rotations are done in software)
; One indicates use 3-beam solution (EX00010)
EX00010

; Set transducer depth to 5meters
ED00050

; External Trigger Output Off
; CX0,0

; save this setup to non-volatile memory in the ADCP
CK